This switch is located in the front passenger’s footwell, behind a flip-up cover, by the kick panel access cover. 1. Turn the ignition to the off position. 2. Check the fuel system for leaks. 3. If no leaks are apparent, reset the switch by pushing in on the reset button. 4. Turn the ignition to the on position. SOURCE: fuel cut off switch for 1990/91 ford escort 1.9. The "inertia switch" which shuts off fuel to the engine in the event of a collision or jolt on a 1991 through 1996 models, as well as on 1998 coupes, is located in the rear of the vehicle, near the right (passenger's side) strut tower. On sedan and coupe models, open the trunk and remove Ford fuel cut off switch (inertia switch) Part 1. Singular Automotive. 693 subscribers. Subscribe. 44K views 2 years ago. Be sure to check for water intrusion into the switch, grounding of 213 POSTS. Also check for corrosion at the fuel-pump cutoff inertia switch. It is located on the passenger side floor, at the front of the carpeting/floor mat near the firewall. It has a red reset switch on it. The connectors on these switches, due to their location, are prone to corrosion. Was this. I have a 2002 f350 7.3 with approx 53k miles. Today I decided to drive to work to put my rear susp on truck started fine got about 1/2 way to the shop so about 20-25 mins of driving, on the highway the truck seemed to bog down and just cut off! All the dash lights were still on so I pulled over on the shoulder popped the hood everything looked . 2006 Ford F-150. Asked by mickie2bluiz in Great Bend, KS on December 20, 2010. where is the fuel relay and fuel shutoff switch located on this vehicle. 1 reply Report. Answer. Popular Answer. DaveJM on December 21, 2010. Fuel cut off switch - passenger front kick panel. Relay - power distribution box under the hood. The fuel shut-off is automatic and requires no unusual actions from the driver. When the driver releases the accelerator pedal, the system temporarily turns off the fuel. The flow of fuel seamlessly resumes when the truck reaches a low speed or the driver accelerates again. To prevent engine hesitation normally associated with fuel interruption For this to work will also need to start/run the motor to use up the fuel in the line. It seems far easier to me to just remove the fuel pump fuse in the engine bay and then start the motor. Of course I have also changed many a fuel filter by just wrapping it in a rag. After swapping the fuel filter, cycle the key on/pause/off several times 1988ranger. Liking the Ford Ranger Forum. Join Date: May 2011. Posts: 17. fuel cut off switch ?????? when my 1988 ranger idles low it will conk's out trips the fuel cutoff switch and then i have to. reset my fuek cutoff switch to get truck to start agian .. my question is should replace my intake gasket so it will idle better. Do not reset the fuel cut-off switch if you see or smell leaking fuel. • Turn the ignition switch to position 0. • Check fuel system for leaks. • If no fuel leak is apparent, reset the switch by pushing in the button (see illustration). • Turn the ignition switch to position II. After a few seconds return the key to position I.

ford fuel cut off switch